How To Wrap an Exhaust

The How To page is for people who want to get their hands dirty, or are thinking about getting them all greased up.

Just watch, learn and ask. Before you know it, you are building your own beauty’s.
These posts will be a combination of collected information from the web and produced by our own.

In this post Lowbrow Customs helps you, cafe racers, with wrapping your Exhausts.

Here, the guys of Lowbrow Customs are wrapping the pipes on a 2007 Triumph T100.

Many people use exhaust pipe wrap for looks, it can also help hide damaged pipes or to hide welds or bad chrome / rust.

Supplies needed are exhaust pipe wrap (a 2″ x 50′ roll used here) and safety wire and safety wire pliers (or hose clamps if you want to go that route).

How To Wrap an Exhaust 1

They pulled the exhaust pipe off to make it easier to show but you can do this on the bike as well. Some people use hose clamps to clamp the beginning and end of the exhaust wrap, but they decided to use safety wire instead for a cleaner look. The safety wire pliers make the job of twisting much easier than doing it by hand.

How To Wrap an Exhaust 2

They wrapped tightly around the pipe with an overlap of approximately 1/4″, following the manufacturer’s directions. They chose to wrap my pipes dry, though Some people wrap the pipes with the exhaust wrap wet to get a tighter wrap.

How To Wrap an Exhaust 3

How To Wrap an Exhaust 4
When they came to the end point of where they wanted to wrap, they cut it a bit long and doubled the end over to keep it from unravelling before safety wiring the end of the exhaust wrap.

How To Wrap an Exhaust 5 How To Wrap an Exhaust 6 How To Wrap an Exhaust 7 How To Wrap an Exhaust 8

Once you finish wrapping your pipes make sure to run the pipe to allow the exhaust wrap to cure.

They would suggest not doing this in your garage or while riding it as it smokes like hell. Once it gets up to temperature it will cure and you will be all set.

How To Wrap an Exhaust 9

Manifold is now done!

A nice video to help you a bit more:

Source

Building a Cafe Racer Yourself?

2 Responses

  1. 3D Fabrication

    I merely wanted to thank you one more time for that amazing blog you have made here. It is full of ideas for those who are definitely interested in that subject, primarily this very post.

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *

17 + 6 =